STEM Through the Trades

Where science class meets the workbench

Most STEM programs teach concepts on paper. We teach them with a tape measure, a speed square, and a low-voltage circuit board. Every trade is a doorway into real science, technology, engineering, and math โ€” the kind you can hold in your hands.

4

STEM pillars, one workshop

6+

trades explored hands-on

0

screens required to learn

100%

learning by doing

The four pillars, built into every unit

Each trades unit is engineered to teach a STEM pillar through a real, hands-on challenge. Students don't just hear about physics โ€” they load-test a truss.

S

Science

Building science, chemistry & physics

Heat, air, and moisture move through walls. Cleaning chemistry follows the pH scale. Water flows by gravity and pressure. Students see science happen in their hands.

  • Test insulation R-values under a heat lamp
  • Observe how a P-trap water seal blocks sewer gas
  • Match acidic vs alkaline cleaners to the right surface
T

Technology

Tools, measurement & low-voltage circuits

From tape measures to multimeters, technology is how trades get precise. Students learn to read instruments, use digital levels, and wire safe low-voltage circuits.

  • Read voltage, resistance, and continuity on a multimeter
  • Use a digital level and laser distance tools
  • Wire a 3-way switch on a 12V bench board
E

Engineering

Framing, structure & problem-solving

Every build is an engineering problem: loads, spans, fasteners, and material choice. Students design, test, and revise โ€” just like real engineers.

  • Build and load-test a miniature roof truss
  • Engineer a cut list to minimize material waste
  • Solve a framing layout from a floor plan
M

Math

Measurement, fractions & estimating

Fractions, area, geometry, and estimating stop being abstract the moment a cut list depends on them. Math becomes a tool students actually use.

  • Add fractions to total a cut list
  • Calculate area and material take-offs
  • Lay out 90ยฐ and 45ยฐ angles with a speed square

STEM challenges students actually build

Each challenge starts with a driving question โ€” the same way real engineers and trades pros approach a problem.

Carpentry

The Load-Bearing Truss

"How much weight can a triangular truss hold before it deflects?"

EngineeringMathScience
Electrical

The 3-Way Switch Puzzle

"How can two switches control one light from opposite ends of a room?"

TechnologyEngineering
Plumbing

The Drain Slope Challenge

"Why does a drain need exactly 1/4 inch of fall per foot?"

MathScienceEngineering
Building Science

The Insulation Heat Box

"Which insulation keeps a box coolest under a heat lamp, and why?"

ScienceEngineeringMath
Cleaning & Sanitation

The pH Surface Match

"Why does vinegar dissolve mineral scale but not grease?"

ScienceTechnology
Construction Math

The Cut-List Optimization

"How do you cut the most pieces from one board with the least waste?"

MathEngineering

Every trade is a STEM lesson in disguise

Carpentry

Engineering & Math

Electrical

Technology & Science

Plumbing

Science & Math

Cleaning

Chemistry & Science

Construction Math

Math & Engineering

Estimating

Math & Technology

Building Science

Science & Engineering

Framing

Engineering & Math